WISP4.1DL

(Current Release - Blue WISP)
Questions? - yeagerd yeagerd and - alanson alanson maintain this page.

WISP_4.1DL_Photo_Back.jpgWISP_4.1DL_Photo_Front.jpg

Overview

This is the latest release with all the usual refinements.
  • Schematic and CAD files have been update with new demod cap values and supervisor part number.
  • PCB layout had not changed

Features

MSP430F2132 Microcontroller
ADXL330 3-Axis Accelerometer
LM94021 Temperature Sensor (as well as the MSP430 internal sensor)
1.8V 8k I2C EEPROM
Analog Voltage Sensing
Capacitance Sensor

Programmer

WISP_4.1DL_Programmer.jpg
Green programmer, says WISP4.1DL on it.
Here are the Altium CAD files along with Gerbers needed for fabrications. WISP 4.1 Programmer.zip

Schematics



PCB Layout



Pin Definition Header File



PCB CAD Files: Altium Designer + Gerbers





Relevant Datasheets

MSP430F2132 : webpage - datasheet - user guide

Known Bugs


1. Capacitor in Demodulator is Too Big:
We found a bug in the demodulator circuit. The 1.0uF capacitor was too big, which meant that reader commands were decoded incorrectly, particularly when decoding long commands (such as READ) or many commands in sequence (such as the Gen 2 singulation process). Changing the capacitor (C2 in the PCB layout) from 1.0uF to 0.1uF fixes this problem. illustrates the problem with the large cap; bit_line drops below bit_pwr. It shows the WISP trying to decode reader commands, including a long series of QReps, most of which are missed. shows the same experiment with the new cap. shows the impact the change has when using the READ command to return sensor values; using the old cap collapses at a certain point, where a WISP with the new cap degrades gracefully.
The CAD files have been update to reflect this change (version 8).


2. LED Orientation

Our board assembly house likes to stuff LED backwards. The dot in the LED should be nearest the demodulator


3. Seiko S1000 miss labeled footprint

The schematic specifies the S1000C20-14T1 (which is incorrect), however the BOM is correct.
The correct part number is the S-1000C20-N4T1 which has the SC-82AB footprint.
http://datasheet.sii-ic.com/en/voltage_detector/S1000_E.pdf
The CAD files have been update to reflect this change (version 8).

Comparison of voltage supervisors

In response to the low availability of S1000 devices, here is a list of some 2.0V voltage supervisors that would be suitable for the WISP. Please note that not all devices listed are directly compatible with the footprint used on WISP. See the package compatibility notes.


Firmware Snapshots and Applicable Reader

Intended for Impinj Speedway Reader, may also work with ThingMagic Development kit reader (using Intel reader chip).



The last modification was made by - anparks anparks on Jan 4, 2012 5:55 pm